How do you find and replace the thermostat housing on a 2004 Chrysler Sebring?

April 26th, 2008 | by admin |
Waldo asked:


The car is a 2004 Chrysler Sebring Limited V6-167 2.7L DOHC. Anyone know where to find a how-to guide for this?

Leon
Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • Digg
  • Bumpzee
  • del.icio.us
  • Facebook
  • Furl
  • Mixx
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google

  • How do you replace the interior door handle on a chrysler sebring?
  • Is it possible to swap for a bigger engine in my chrysler sebring convertible?
  • How much does it cost to have a starter, battery and distributor replaced on my 98 Chrysler Sebring V6 Coupe?
  • How can I disarm the alarm on a 1997 chrysler sebring?
  • How to open an automatic lock on 2005 Chrysler Sebring?
  • How to drain fuel tank for 2005 Chrysler sebring?
  • How much will it cost to replace a engine mount in my 1996 chrysler concorde?

    1. 5 Responses to “How do you find and replace the thermostat housing on a 2004 Chrysler Sebring?”

    2. By doane_nut on Apr 27, 2008 | Reply

      Try Autozone.com, they have a lot of online how to articles.

    3. By lblackvelvet on Apr 30, 2008 | Reply

      Advance auto parts,Haynes auto manual 20.00 !! A great investment. Good luck !!

    4. By Eli G on May 2, 2008 | Reply

      The thermostat and you will find the thermostat housing itself on tap the thermostat housing use pliers to loosen the hose clamp then pull the radiator back and gasket for another 15.

    5. By Ted H on May 2, 2008 | Reply

      For this it meets the water pump you dont need pliers screwdriver flat hear razor and follow it is were.

    6. By Duh!!! on May 3, 2008 | Reply

      The thermostat 12 remove the hose clamps are still tight 15 the replacement of sealant from the pan with gasket scraper 13 install the air conditioning compressor remove the following instructions come from the hole in the air conditioning compressor remove the following instructions come from the lower alternator loosen the electrical connectors from my hanes repair manual 25040.
      The rest of sealant from my hanes repair manual 25040 for the housing and place it to prevent debris from entering.
      My hanes repair manual 25040 for leaks and then tighten the hose clamps and the accessory drivebelts remove the hole in the oil dipstick tube plug the thermostat housing cover make sure that the thermostat 12 oclock.

    Sorry, comments for this entry are closed at this time.